MUTOH Rockhopper II Series Betriebsanweisung PDF herunterladen (Seite 76)

Handling Roll Media – User’s Guide

AP-75100, Rev. 2.0, 26/11/04

2. Adjust the start sensor

Step 1 : Make sure that the start sensor is not covered and the “Automatic” switch is set to “Manual”.

(Switch in the up position.)

Step 2 : Hold (or ask someone to hold) the front tensioning system in the 25° position. (Please see to the

angle markings on the front tensioning system. Please refer to the section “Angle mark front

tensioning system”.)

Step 3 : Switch the Front to AUTOMATIC. (Toggle the switch down.)

¾ The “Automatic” LED will start blinking.

¾ The front motor will start turning at the initial speed (very low!).

Step 4 : Rotate (“upwards”) the adjustment lip carefully until the start sensor is covered. (For the

adjustment direction, please refer to the section “Sensor disc and adjustment direction”.)

¾ The “Automatic” LED will light continuously.

¾ The front motor will start accelerating.

1 = Rear stop adjustment direction 2 = Rear start adjustment direction

3 = Front stop adjustment direction 4 = Front start adjustment direction

Step 5 : Tighten the start screw on the adjustment lip.

Notes :

¾ If necessary during adjustment, return to the initial speed by toggling the “Automatic”

switch to manual and back.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 94 95

Keine Kommentare

MUTOH Rockhopper II Series Betriebsanweisung Seite 76